Required Tools

Click here to view a print friendly version of the Asset Program required tool list.

1/4 inch Drive

1 –1/4” Drive ratchet

1 –1/4” Drive socket set - 3/16 – 3/8” and 4mm – 13mm recommended

1 – Extension 2”

1 – Extension 6”

1 – Drive handle

3/8 inch Drive

1 – 3/8” Drive ratchet – approximately 8” in length

1 – 3/8” Drive extension – 1” in length

1 – 3/8” Drive extension – 3” in length

1 – 3/8” Drive extension – 12” in length

1 – 3/8” Drive shallow and deep socket set – 1/4 - 7/8 6 pt. Recommended

2 – 3/8” Drive spark plug socket - 5/8” (flex recommended)

1 – 3/8” Universal

1 – 3/8” Drive shallow and deep metric sockets – 7mm - 19 mm

1 – Set Torx drive bits

1/2 inch Drive

1 – 1/2" Drive ratchet

1 – 1/2" Drive socket set 7/16 - 1” and 8mm – 21mm

1 – 1/2" Breaker bar 18”

1 – 1/2" Drive extension 3”

1 – 1/2" Drive extension 10”

1 – Adapter 1/4 – 3/8”

1 – Adapter 3/8 – 1/2"

1 – 1/2" Drive impact socket 3/4 & 13/16”

1 – 1/2" Drive impact socket 19mm

Wrenches

1 – Set combination box – open end wrenches – 1/4 – 1”

1 – Set metric combination wrenches 9 – 19mm

1 – Set Allen wrenches – standard

1 – Set metric Allen wrenches

1 – Set metric flare wrenches

1 – Crescent wrench – 10”

 

Pliers

1 – Pair slip joint

1 – Pair diagonal cutting

1 – Pair needle nose

1 – Pair adjustable joint (channel lock)

1 – Pair vise grip

Screwdrivers

5 – Straight blade – 1 each: stub, small, medium, medium large, large

3 – Phillips screwdrivers - #1, #2 and #3

1 – Set Torx drive screwdrivers

Miscellaneous Tools

1 – Tool chest, lockable with drawers

1 – Center punch

3 – Punches – 1/8, 3/16, 5/16”

2 – Chisels – 7/16, 5/8”

1 – Plastic tip hammer

1 – Set of Ball Peen hammers

1 – Rubber/Plastic mallet

1 – Pair safety goggles/glasses (ANSI Z-87 approved)

1 – Tire pressure gauge

1 – Valve core remover

1 – Hand file flat with handle 10”

1 – Gasket scraper

1 – Knife

1 – Pry bar set

1 – 12 volt test light

1 – Flashlight

1 – Set feeler gauges – flat, metric and standard graduations

1 – Oil filter wrenches

1 – Brake tools – return, hold down

1 – Brass drift

1 – Measuring tape

1 – Inspection mirror

1 – Pick-up magnet

1 – Spark plug gap adjusting tool – round wire type – .024” to .080”

1 – DVOM – 10 Meg-ohm input impedance